In ROM BIOS, the acronym BIOS stands for:
1.Basic Intuitive Output Set
2. Basic Input Organizational System
3. Basic Input Output System
4. Basic Industry Operating System
Posted Date:-2021-02-20 12:43:33
After you service a laser printer, you notice dirty print. Which of the following would correct the problem.
1. Clean the developer tank
2.Reset the printer
3.Run several blank pages
4.Clean the laser diode
Posted Date:-2021-02-20 12:43:33
After you service a laser printer, you notice dirty print. Which of the following would correct the problem?
1.Clean the developer tank
2.Reset the printer
3.Run several blank pages
4. Clean the laser diode
Posted Date:-2021-02-20 12:43:33
During the boot process, a system first counts memory from where?
1. Expansion memory board
2.Video adapter
3.System board
4.Cache
Posted Date:-2021-02-20 12:43:33
A PCMCIA measuring 10.5mm is what type?
1.type 1
2.type 2
3.type 1 and 3
4. type 3
Posted Date:-2021-02-20 12:43:33
Modems use _____ transmission.
1.Synchronous
2.Asynchronous
3.Timed interval
4.PPP
Posted Date:-2021-02-20 12:43:33
What command is used to hand up a MODEM when using the "AT Answer Command set"?
1.ATZ
2.ATD
3.ATR
4.ATH
Posted Date:-2021-02-20 12:43:33
What command is used to reset a MODEM when using the
1.ATR
2.ATZ
3.DTR
4.DCE
Posted Date:-2021-02-20 12:43:33
What component would most likely cause a "parity error"?
1.bad hard disk
2.bad controller
3.bad RAM
4.bad software
Posted Date:-2021-02-20 12:43:33
What should he used to extinguish a computer fire?
1.fire hose
2.class a extinguisher
3.class c extinguisher
4.silver foam water
Posted Date:-2021-02-20 12:43:33
Whenever you have a hardware resource conflict, it will more likely be an IRQ conflict rather than an i/o conflict because:
1.there are a lot more I/O addresses than IRQs.
2. the BIOS sometimes has more of a problem controlling IRQs
3.I/O addresses cannot conflict
4.software tends to correct I/O conflicts
Posted Date:-2021-02-20 12:43:33
Which hardware component controls serial port communications?
1.ROM BIOS
2.CPU
3.DMA823
4.UART 16550
Posted Date:-2021-02-20 12:43:33
Why does a successfully mapped network drive disappear every time you boot the computer?
1.The computer you are connected to has moved
2.You didn't click reconnect on log on
3.The map statement is not in the autoexec.bat file
4.The last drive was not set correctly
Posted Date:-2021-02-20 12:43:33
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
1.The port speed is set too high
2.the modem has not been set up in control panel properties
3.the phone line is plugged into the line-in port on the modem card
4. the phone line out of the wall is plugged into the phone port on the modem card
Posted Date:-2021-02-20 12:43:33